Arcadia Jungle Dawn LED Light Risers for Reptile Enclosures (Set of 2)

Lift your Arcadia Jungle Dawn LED bar, standard or LumenIZE, off the mesh with a set of two freestanding PETG risers. Each riser stands on your enclosure's screen top on two angled legs, and the end of the light bar slides into the holder at the top. No screws, brackets or tools needed.

Sold as a set of 2

Your order includes 2 risers in the height you choose, one for each end of the light bar.

Why you'll like it

• No hardware needed: The risers stand on the mesh. Slide the ends of the light bar into the holders and you're set.
• Air gap under the light: Raising the bar keeps it off the screen, so air can move freely around the heatsink and heat isn't trapped against the mesh.
• Stable stance: Two angled legs splay out from each holder, so the risers stay upright on mesh.
• Anchoring tabs: Each foot has a tab with a screw hole, so you can anchor the risers down if you want extra security. Use #6 screws for a cleaner look, or thread a small zip tie through the hole to tie them to the mesh. Screws and zip ties are not included.

Choose your height

• Tall: 110 mm (4.33")
• Short: 90 mm (3.54")

Fit check before you order

Fits both the standard Arcadia Jungle Dawn LED bar and the Arcadia LumenIZE Jungle Dawn LED bar.

Why PETG instead of PLA

• Handles the heat: An LED heatsink and warm, humid tropical air will slowly soften and warp PLA, which starts to give at roughly 55 to 60°C. PETG holds its shape up to a glass transition of around 80°C, so it won't creep or sag.
• Handles the humidity: PETG absorbs very little water, roughly 0.2% or less by weight, so misting, rain systems and high humidity won't swell or weaken it.
• Easy to clean: It stands up well to wiping down with reptile-safe and terrarium-safe cleaners.