Arcadia T5 LumenIZE Pro UVB Light Risers for Reptile Enclosures (Set of 2)

Lift your Arcadia T5 LumenIZE Pro UVB fixture off the mesh with a set of two freestanding PETG risers. Each riser stands on your enclosure's screen top, and the end of the fixture presses up into a pocket under the arch, where retention ribs grip it. No screws, brackets or tools needed.

Sold as a set of 2

Your order includes 2 risers in the height you choose, one for each end of the fixture. Some photos show a tall and a short riser side by side so you can compare the heights. The photos also show both a smooth and a textured print finish. Both are the same PETG part and perform the same.

Why you'll like it

• Snug, secure hold: The pocket narrows from 27 mm to 25 mm at the retention ribs, so the fixture stays seated instead of sliding around.
• Air gap under the lamp: Raising the fixture keeps it off the screen, so warm air can move under and around it.
• Another way to tune your UVB: UVB strength drops as the lamp moves farther from the basking spot, so the riser height gives you one more way to set the distance. Check the UV index at the basking spot with a UV meter after any change.
• Wide, stable stance: The feet sit about 184 mm apart, so the risers stay upright on mesh.
• Anchoring tabs: Each foot has a tab with a screw hole, so you can anchor the risers down if you want extra security. Use #6 screws for a cleaner look, or thread a small zip tie through the hole to tie them to the mesh. Screws and zip ties are not included.

Choose your height

• Tall, 110 mm (4.33"): 80 mm (3.15") of clearance under the arch.
• Short, 90 mm (3.54"): 60 mm (2.36") of clearance under the arch.

Fit check before you order

Sized for the Arcadia T5 LumenIZE Pro fixture only. It will not fit the standard Arcadia T5 UVB fixtures. For those, see my T5 UVB risers.

Dimensions (each riser)

• Height: 110 mm (tall) or 90 mm (short)
• Width: 184.5 mm, foot to foot
• Thickness: 15 mm
• Pocket: 27 mm wide (25 mm at the ribs), 20 mm deep

Why PETG instead of PLA

• Handles the heat: A T5 HO fixture warms everything it touches, and PLA starts softening at roughly 55 to 60°C. PETG holds its shape up to a glass transition of around 80°C, so the risers won't sag or creep under the fixture during long daily light cycles.
• Handles the moisture: PETG absorbs very little water, roughly 0.2% or less by weight, so it won't swell, warp or weaken from misting, humid substrates or the moisture swings of tropical and desert setups.
• Easy to clean: It is chemically resistant enough to wipe down with standard reptile-safe enclosure cleaners.